Reference number
ISO/ASTM 51818:2020
International Standard
ISO/ASTM 51818:2020
Practice for dosimetry in an electron beam facility for radiation processing at energies between 80 and 300 keV
Edition 4
2020-06
Preview
ISO/ASTM 51818:2020
79633
No disponible en español
Publicado (Edición 4, 2020)

ISO/ASTM 51818:2020

ISO/ASTM 51818:2020
79633
Idioma
Formato
CHF 96
Convertir Franco suizo (CHF) a tu moneda

Resumen

This practice covers dosimetric procedures to be followed in installation qualification, operational qualification and

performance qualification (IQ, OQ, PQ), and routine processing at electron beam facilities to ensure that the product has been treated with an acceptable range of absorbed doses. Other procedures related to IQ, OQ, PQ, and routine product processing that may influence absorbed dose in the product are also discussed.

The electron beam energy range covered in this practice is between 80 and 300 keV, generally referred to as low energy.

Dosimetry is only one component of a total quality assurance program for an irradiation facility. Other measures may be required for specific applications such as medical device sterilization and food preservation.

Other specific ISO and ASTM standards exist for the irradiation of food and the radiation sterilization of health care products. For the radiation sterilization of health care products, see ISO 11137-1. In those areas covered by ISO 11137-1, that standard takes precedence. For food irradiation, see ISO 14470. Information about effective or regulatory dose limits for food products is not within the scope of this practice (see ASTM F1355 and F1356).

This document is one of a set of standards that provides recommendations for properly implementing dosimetry in radiation processing, and describes a means of achieving compliance with the requirements of ISO/ASTM 52628. It is intended to be read in conjunction with ISO/ASTM 52628.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Informaciones generales

  •  : Publicado
     : 2020-06
    : Norma Internacional publicada [60.60]
  •  : 4
     : 13
  • ISO/TC 85
    17.240 
  • RSS actualizaciones

¿Tiene alguna duda?

Consulte nuestras Ayuda y asistencia