Reference number
ISO 20290-4:2019
International Standard
ISO 20290-4:2019
Aggregates for concrete — Test methods for mechanical and physical properties — Part 4: Determination of ten percent fines value (TFV)
Edition 1
2019-11
Preview
ISO 20290-4:2019
74018
Indisponible en français
Publiée (Edition 1, 2019)

ISO 20290-4:2019

ISO 20290-4:2019
74018
Langue
Format
CHF 63
Convertir les francs suisses (CHF) dans une autre devise

Résumé

This document gives the test method for determination of ten percent fines value (TFV) of aggregates. This method gives a relative measure of the resistance of the aggregate crushing under the gradually applied compressive load.

It covers two sets of procedures:

— the first procedure is applicable for aggregates tested in dry condition; and

— the second procedure is applicable for aggregates tested in a soaked condition.

NOTE 1 Generally, the test can be done under dry conditions. However, the engineer in charge can choose to test them in soaked condition, if necessary.

The method is applicable to aggregates of different strengths covering both weak and strong aggregates. It is applicable to standards aggregates, i.e. passing a 14,0 mm test sieve and retained on 10,0 mm test sieve.

National standards can also exist for the aggregate size fraction to be taken for this test. In case this definite size fraction is not available, the test can be made on other sizes, given in Annex A. The comparison of results of non-standard sizes with standard size aggregates is not possible due to lack of available data.

NOTE 2 Minor variations in grading divisions can be allowed in respective national standards.

Informations générales

  •  : Publiée
     : 2019-11
    : Norme internationale en cours d'examen systématique [90.20]
  •  : 1
  • ISO/TC 71/SC 1
    91.100.30 
  • RSS mises à jour

Vous avez une question?

Consulter notre Aide et assistance