Draft
International Standard
ISO/DIS 22514-7
Statistical methods in process management — Capability and performance — Part 7: Capability of measurement processes
Reference number
ISO/DIS 22514-7
Edition 3
© ISO 2024
Проект Международный стандарт
Preview
недоступно на русском языке
В стадии разработки
Проект данного международного стандарта находится на этапе рассмотрения членами ИСО.
Текущее издание: ISO 22514-7:2021

ISO/DIS 22514-7

Язык
Формат
CHF 63
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This document defines a procedure to validate measuring systems and a measurement process in order to state whether a given measurement process can satisfy the requirements for a specific measurement task with a recommendation of acceptance criteria. The acceptance criteria are defined as a capability figure (CMS, CMP) or a capability ratio (QMS, QMP).

NOTE       This document follows the approach taken in ISO/IEC Guide 98-3 (GUM), and establishes a basic, simplified procedure for stating and combining uncertainty components used to estimate a capability index for an actual measurement process.

This document is primarily developed to be used for simple one-dimensional measurement processes, where it is known that the method uncertainty and the specification uncertainty are small compared to the implementation uncertainty. It can also be used in similar cases, where measurements are used to estimate process capability or process performance. It is not suitable for complex geometrical measurement processes, such as surface texture and position measurements that rely on several measurement points or simultaneous measurements in several directions.

Общая информация

  • Текущий статус
     : В стадии разработки

    You can help develop this draft international standard by contacting your national member

    Этап
    : Начало голосования по проекту между-народно-го стандарта: 3 мес. [40.20]
  • Версия
     : 3
  • Технический комитет :
    ISO/TC 69/SC 4
    ICS :
    03.120.30 
  • RSS обновления

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 03
  6. 03.120
  7. 03.120.30
  8. ISO/DIS 22514-7