ISO 6162-1:2012
2012-12
Abstract
ISO 6162-1:2012 gives general and dimensional specifications for flanged heads, split flange clamps (FCS and FCSM), one-piece flange clamps (FC and FCM), ports and mounting surfaces applicable to four-screw, split and one-piece flange clamp type tube connectors and hose fittings for use at pressures of 3,5 MPa (35 bar ) to 35 MPa (350 bar). It also specifies the dimensions of the seals to be used, as well as the grooves that house the seals.
ISO 6162-1:2012 also recognizes the need to accommodate metric screw fasteners (type 1), as well as to provide a means to use existing inch screw fasteners (type 2).
These connections are intended for application in hydraulic systems on industrial and commercial products where it is desired to avoid the use of threaded connectors.
Surges of pressure higher than the nominal ratings will reduce the ability of the flange connections to retain the hydraulic fluid. This needs to be taken into account in the design of the hydraulic system.
General information
-
Status: PublishedPublication date: 2012-12Stage: International Standard to be revised [90.92]
-
Edition: 2Number of pages: 21
-
Technical Committee :ISO/TC 131/SC 4ICS :23.100.40
- RSS updates
Life cycle
-
Previously
WithdrawnISO 6162-1:2002
WithdrawnISO 6162-1:2002/Cor 1:2004
-
Now
-
Will be replaced by
Under developmentISO/CD 6162-1
